About Foot Pedal Controllers Many actions in Express Scribe can be controlled by a foot pedal controller. Each button or pedal on the controller can be mapped to a command that is triggered when that button or pedal is pressed. Foot pedal controllers allow you to trigger commands without removing your hands from the keyboard or mouse, in a more intuitive way than keyboard short-cuts or hot-keys. See Controllers ~ Compatible Controllers for a list of controllers that are compatible with Express Scribe. Button or pedal presses on controllers are detected regardless of whether or not Express Scribe is in the foreground or has focus. The controller will continue to function even when Express Scribe is minimized, or while using a document in another application. Active Controller The "active controller" is the controller that has been configured for use. See Foot Pedal and Hand-Held Controller Setup Guide and Settings ~ Control for information about configuring the active controller. Note that if the active controller is unplugged and moved to a different port, it will no longer be detected as the active controller. You must either reconnect the controller to the original port, or run the Controller setup wizard again. Controller Status An icon representing the status of the active controller appears on the right-hand side of the status bar. The icon has four possible states: - Black icon, green dot: The active controller is attached and configured correctly.
- Black icon, orange dot: The active controller is configured, but is not attached.
- Black icon, red dot: The active controller is not configured correctly, or an error has occurred.
- Gray icon, no dot: The controller feature is disabled
Hover the mouse cursor on top of the status icon for a text description of the controller status. If the controller feature is enabled but no active controller is configured, a message may appear in the notification tray area when you attach a plug and play controller. Click on this message to launch the Controller setup wizard and configure it as the active controller. |